SuperMoto Junkie banner
1 - 3 of 3 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Ok, so my ride is a wr450 2013.
I took out the small silencer, but felt the bike very restricted, so I took out the oem baffle/silencer...


Made my own baffle (60mm diameter) and packed it around with ceramic wool...


Now, it is a little loud, sometimes, specially when late night driving in the neighborhood (otherwise it’s awesome), so I stretch my arm and silence it a bit when passing by houses at night... I thought of a exhaust valve, and was wondering if any one has done this before... here is the valve


This is to be activated remotely through a cable (just like a carb choke through wire)... I just don’t want to put a screw-in screw-out db killer...

Any thoughts???

Here is the ride...
 

·
Registered
Joined
·
18 Posts
Discussion Starter · #4 ·
Ok... so welding the yamaha r6 exhaust valve, was imposible because it was some titsnium alloy... so I had to assemble the components in a stainless steel tube...


Then, cut tube as close to the silencer as possible so the valve is kind of tuvked in there...


I also tig soldered a bung so a O2 sensor for the wideband can be installed...


A little sanding, brushing and polishing....


This is the valve alignment


The cap on the back, which is stanless steel serves as the end cap...
 
1 - 3 of 3 Posts
Top