SMS630 help

1700 Views 6 Replies 4 Participants Last post by akaDan, May 25, 2011

70RSMAT

Discussion Starter · May 24, 2011

Hi,

I'm picking up an fmf slip on for my bike tomorrow, does the mid pipe for this come with a hole for the lamba sensor and a block off piece?

I also should be getting a power commander fitted and set up with a custom map next week

so my question is, what do i do with the lamba sensor? does it need to be blocked off before i can use the power commander? if so, where can i buy the kit to do this (aka the power up kit?) in the UK

so many questions! :headscrat

Save

1 - 7 of 7 Posts

dc.allen

· #2 · May 25, 2011

the fmf pipe doesn't go that far up the factory midpipe.

Save

70RSMAT

Discussion Starter · #3 · May 25, 2011

It does, I have it sat in front of me now

and it has the hole ready for the lamba sensor

Save

Clean

· #4 · May 25, 2011

70RSMAT said:
It does, I have it sat in front of me now and it has the hole ready for the lamba sensor

Any pics? I just ordered a factory4.1 for my SM630. I can't find any decent pictures of it online.

Once I get the pipe, I'm planning order a Power Surge 6x. I really like what the 6x did for my TE310.

Save

70RSMAT

Discussion Starter · #5 · May 25, 2011

heres a few bad phone pics, i'll try to get some decent ones and a vid tomorrow. It is very loud though, im pleased i went for the Q4, the 4.1 will be even louder! Surprisingly i think it runs smoother when you're actully riding but it tends to cut out more when you pull up.

anyway guys, i need to know, will a powercommander work properly with the lamba sensor still in place? my husky dealer is being awkward about it and it looks like i might have to make my own resistor/blank off but i really need the fuelling 100% as well

cheers

See less See more

Save