SuperMoto Junkie banner

1 - 5 of 5 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
So after numerous attempts at getting the DRZ running after the bigbore and hotcam install to no joy I decided to tonight pull her down once again to figure out wtf is goin on. Previous attempts at starting only resulted in mayb 10 seconds running and a nice big backfire followed by a 4ft flame!!! Pretty :lol:

Anyways after pulling the cams out and checking the valve seats this is why I think she wont run! One of the valve keepers is sitting about 2-3mm above the other causing one of the exhaust valves to remain open!
 

Attachments

·
Registered
Joined
·
5,345 Posts
Time to send the head off to Eddie:clap:
 

·
Registered
Joined
·
88 Posts
Discussion Starter · #5 ·
Hmmmm yes so tonight I'll pull the motor down for the second time now and see wtf is goin on there..............so anyone used the kibblewhite black diamond valves before??? Theres as full kit on ebay for $240 im thinkin if i gotta pull one valve i might as well do the lot!!

Here's hoping theres no damage to the spankin new piston I put in that didn't even get to see any flame!!!
 
1 - 5 of 5 Posts
Top