SuperMoto Junkie banner

My Husaberg Project / Picture thread

157K views 217 replies 69 participants last post by  parriman 
Great...:headscrat

I also think I've had a couple beers too much. I could not get the daymn wheel any better than approx 1.5mm. Threw the spoke wrench toward the wall couple times too.

So fkn annoying job that I think I'm gonna buy some brand new carbon matrix Alpinas soon...
sometimes you're better off to loosen all the spokes a bit, and let the wheel relax, then start over. also, make sure that you grab where the spokes overlap and give it a squeeze every once in awhile, as the spokes will snag on each other, and this will let the tension release. :)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top