SuperMoto Junkie banner
1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 · (Edited)
Super clean, almost new Moto-Master caliper and mounting bracket. The SM-101R mounting bracket I have fits, I believe, all Honda CRF450s with a 320mm brake rotor. But if you replace the mounting bracket, the caliper will fit almost any motard or project bike application (except for radial calipers, of course). Why? Because most Moto-Master calipers are the same, it's just the mounting bracket that differs from application to application. The sintered metal pads are about 80% to 85% or so. This caliper needs nothing, just bolt it on, bleed it and and go racing. Email Linz at RacerBoy97 at gmail dot com or call 713-516-14 two seven.

$180 shipped to the 48 states. No international shipping, sorry.

This caliper was used on a Honda CR500R for a brief amount of time. I built my own mounting bracket for that application. The bike is mostly gone now, parted out. Sorry, I don't have measurements for bolt hole spacing on the SM-101R bracket since I never used this on a CRF of any year. Check with MM on that, I guess.

http://s225.photobucket.com/albums/dd196/Racer997/Moto-Master/

http://i225.photobucket.com/albums/dd196/Racer997/CR500R-4.jpg

http://i225.photobucket.com/albums/dd196/Racer997/TWS4_24_05_01.jpg

http://i225.photobucket.com/albums/dd196/Racer997/a97cc.jpg
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #4 ·
Sold!

I have the CR500 bracket, made for a 1994 model, but fits 1990 through 1994 for sure, and maybe other years. If you want it cheap, send me an email at the above listed email.

Thanks!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top