SuperMoto Junkie banner
1 - 2 of 2 Posts

· Registered
14 Posts
Discussion Starter · #1 ·
Was wondering if you guys have experience with these wheels. I went to install thm today and put the rubber dampeners on the ribs of the wheel and took the sproket support and wedge it in between those... my question/ concern is on the sproket support there is a groove and I cannot get that groove completely flush to the wheel... Its confusing to try and say so here are 2 pictures looking from the rear... the left is the chain and im talking about the shinny part sticking out... I rode around and didnt notice anything wrong with it but i wanna make sure first. THANKS!

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.