SuperMoto Junkie banner

I cut my BIG wrx front fender today, PICS AND VID!

15364 Views 36 Replies 28 Participants Last post by  monumaker
First thing is first, mix a tall drink of choice:arsenal(mine is a captain and coke). First step I measured about 4.5 inches from the tip of the front fender back, cut it straight off. I then use the cut off piece as a template for my trace line and final cuts. Lay the cut off piece over the fender and carefully trace with a utility knife. I made about 4 passes carefully with progressive pressure(DON"T go all the way through yet!). Then from underneath the fender(start on right or left) I cut all the way through the fender. It comes off really clean if you take your time. I then sand the final piece with 100, 150, then 220 grit sandpaper. It came out real nice. Much better than the factory duck bill. I think it looks like a true supermoto bike now.:thumbup: Only thing left to do is go rip up your tires!(tomorrow cuz I had the drinks):bike:
1 - 1 of 37 Posts
The only thing that I would do different is less ice!:drunk:
I'd switch it up to Sailor Jerry rum. It tastes the same, IMO a bit better (it's spiced very nicely), and its stronger, and cheaper!

The fender does look good though!
1 - 1 of 37 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.