At 2mm your stock rotor is probably wore out. Most dirt bikes come with 3mm rotors with a wear limit of 2.5mm.
how big can you go?
how thick of a rotor can you stuff in a stock caliper(front)? :headscrat
my stock rotor is just over 2mm, my aftermarket rotor is close to 4mm thick.
will i run in to any problems like premature wear of pads or rotor? or will the hydrolic system take up the differance?
my stock rotor is just over 2mm, my aftermarket rotor is close to 4mm thick.
will i run in to any problems like premature wear of pads or rotor? or will the hydrolic system take up the differance?
1 - 1 of 5 Posts
1 - 1 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
SuperMoto Junkie
A forum community dedicated to SuperMoto owners and rally enthusiasts. Come join the discussion about on and off road racing, performance, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
