SuperMoto Junkie banner

1 - 8 of 8 Posts

·
Registered
Joined
·
471 Posts
Discussion Starter #1
I just bought a new to me cr80 motard (picking up thursday, thanks mikeinwi!)

My local kart track requires axle sliders, anyone come up with an innovative solution or will I have to drill and tap the axles? Will the SME crf150 axle blocks fit?

Harrison
 

·
Registered
Joined
·
471 Posts
Discussion Starter #3
what are you running in the front? Did you drill and tap or figure something else out?
 

·
Registered
Joined
·
471 Posts
Discussion Starter #5
According to SME it's the way to go (drill and tap), but of course I was hoping for a more creative (i.e. cheap and easy) way to go.
 

·
Registered
Joined
·
104 Posts
Luckly,I just checked and i can do all of it in my lathe , i wasnt looking foward to trying this in a drill press.:):):):):):):D
 

·
Registered
Joined
·
471 Posts
Discussion Starter #7
well do to sets and send the extra my way then .. ;)
 

·
Registered
Joined
·
471 Posts
Discussion Starter #8
I was looking at my 80 tonight, any reason to not use the fork shroud mounting hole for the front sliders?
 
1 - 8 of 8 Posts
Top