jetting process

[kavalero]

My fuel mixture screw has no plug or something (as pictured) so no drilling required .. screwdriver only.

after reading I believe the following is the way to go for me (sea level, rs2, 3x3):

Blue needle, 4th clip from the top (flat end of needle)

160 main jet

22.5 pilot jet w/ the Kientech fuel screw, 25 pilot jet w/ the oem fuel screw.

2 3/4 turns out on either fuel screw.



.. so I understand if I use the stock 22.5 pilot then I install Kientech screw

or

if I use 25 pilot from my JD kit then I use stock fuel screw? Correct?


Which way to go?

Thanks

[kavalero]